Transmissions Anti-Vibration Mounts Stud Mounts Type B Bobbin Anti Vibration Mount
Quick Code: BB-357600

Bobbin Type B 80mm OD x 75mm Rubber Metal Anti Vibration Mount

Available on back order - there is an increased lead time on this item. Please contact us for availability.  
£37.78 exc VAT (£45.34 inc VAT)
Available for back order   Free Delivery Available  
Buy Now
Qty:
Product Specification
Outside Diameter (A)
80mm
Stud Dia (C)
M14
Stud Length (H)
35mm
Width (B)
75mm
Reference
121106
Brand
AMC
Quick Order Code
BB-357600
Product Description

The AMC bobbins are devices for making elastic anchorings or fixings. They can be used in a wide variety of applications, particularly for elastic suspensions and anti vibration isolation of machines and different mechanical organs. Type B bobbins are made of a block of rubber with two parallel metal parts at the end and can be fixed with a combination of nuts and screws. The rubber block may be cylindrical in cases requiring greater load capacity or as a diabolo when greater elasticity is required in all directions.

Depending on the size of the rubber block, the AMC bobbing has more or less elasticity, which is greater particularly in all directions perpendicular to its axis (shear). The bobbing thus makes it possible to make joins which permit major relative movements, up to several millimetres (in the case of heat expansion, chassis deformations, etc.). It serves very well for the vibration isolation of machines where the vibrations are perpendicular to their axis, unless these stresses are too much when applied in this direction.

Applications

Suitable for installation on small motor-pumps, motor-ventilators, driers, sieves, compactors, washing machines, electrical motors, on-board control panels, measuring apparatuses, control cabinets, microphones, fluorescent tubes, etc.

Its elasticity is much greater in all the directions parallel to the armatures than in the perpendicular direction. The rubber works based on compression or shear depending on the direction it is placed at installation time. This direction is made according to the use and the objective. It is therefore installed with nuts or screws depending on the model chosen, with one part attached to the fixed chassis and the other to the machine to be suspended.

Key Features
  • Easy to install
  • High elasticity (particularly transversal)
  • Economical
  • Data Sheet