Transmissions
Couplings
Clutches
Freewheel with Torque Arm
Quick Code: BB-558281
REGV 35 Renold Freewheel Self Centering with Torque Arm
Also Try
Freewheel with 62 Series Bearing
Sprag Clutch
Trapped Roller Freewheels
Petrol Engine & Other Spares
Buy Now
Qty:
Product Specification
Quick Order Code
BB-558281
Product Description
Renold REGV Series Trapped Roller Freewheels are self-centering by means of plain bearings.
Torque is transmitted to the inner race via a key and the outer race via the torque arm. Shaft tolerance must be h6.
The primary use for the REGV freewheels is as a backstop. The freewheel should be fixed to the machine body by placing brackets on either side of the torque arm or by using a pin or bolt in the slot. Note that a clearance of 1% of slot width is needed between torque arm and brackets or slot and pin. If a bolt is used instead
of a pin it must not apply any axial loads to the torque arm.
An alternative application would be indexing where a push rod is connected to the torque arm slot. Clearance between slot and pin must be 1% of slot width.
The REGV is supplied pre-filled with grease annormally requires no further sealing.
