http://www.bearingboys.co.uk/wordpress for all your bearing and power transmission needs Wed, 08 Feb 2012 10:00:51 +0000 http://backend.userland.com/rss092 en The waste bins at an industrial site may need replacing on a regular basis due to the poor condition in which they are kept by their users. But this doesn’t always have to be the case. Companies can save thousands of pounds every year if they repair the waste bins ... http://www.bearingboys.co.uk/wordpress/2012/02/08/choosing-wheelie-bin-castors/ Most bearings are used in industrial environments in which they are exposed to all degree of contaminants. These may include, dust, dirt, water and general grime. Because of this bearings which work in places like this need to be checked regularly to make sure they are in good working condition. Maintenance ... http://www.bearingboys.co.uk/wordpress/2012/02/05/how-to-maintain-shielded-bearings/ Choosing a replacement bearing is normally quite easy when you have access to the bearing reference number. This is the combination of numbers and letters which is engraved onto the side one of the bearing’s races. However, it is very common for this number to wear off after time and ... http://www.bearingboys.co.uk/wordpress/2012/02/03/measuring-bearings-correctly/ The balls, rollers and races are perhaps the most well known parts of a bearing. But there is another component in the bearing which pays an extremely important part in the bearing functioning correctly. And unfortunately this part is commonly overlooked in bearing selection choice – the bearing cage. A bearing ... http://www.bearingboys.co.uk/wordpress/2012/02/01/choosing-bearing-cages/ Any rotating part need to be adequately lubricated to reduced friction between metal-to-metal surfaces. If the lubrication is not the right type or in the wrong volumes, friction and hence temperature may increase and cause damage to the rotating parts. In some situations the lubricant in a bearing may break down ... http://www.bearingboys.co.uk/wordpress/2012/01/31/bearing-lubrication-part-2/ Correct and adequate lubrication plays an important role in the performance and lifecycle of any rotating part. When there is metal-to-metal contact between parts there will always be a degree of friction which can cause wear and failure. If the correct lubricant is used between these parts however, a protective ... http://www.bearingboys.co.uk/wordpress/2012/01/30/bearing-lubrication-part-1/ When replacing any of the belts in a drive system, it is important to use the same belts across the drive. This way the belts will all perform within the same parameters and future belt failure will be minimised. V Belts and wedge belts are available from many different manufacturers, so ... http://www.bearingboys.co.uk/wordpress/2012/01/28/replacement-drive-belts/ Grease is the most common lubricant used in bearing manufacture and maintenance. Its properties are suitably apt for conditions in which a bearing may work and its ease of use means that relubricating a bearing is made easy. However, when bearings are relubricated at stipulated maintenance intervals it is important ... http://www.bearingboys.co.uk/wordpress/2012/01/27/bearing-grease-compatibility-problems/ Two of the most common types of bearings in use today are roller bearings and ball bearings. These bearings are used in all types of applications, from the bearings used in car wheel hubs to the bearings used in your computer hard drive. Both roller bearings and ball bearings have ... http://www.bearingboys.co.uk/wordpress/2012/01/26/the-inherent-difference-between-roller-bearings-and-ball-bearings/ Many of the tools maintenance engineers use in industry are much better in terms of quality and durability than those you would find in your regular DIY store. So it’s always better to buy your tools from an industry supplier than turn to a cheaper alternative. Electrician’s tool kits An electrician needs ... http://www.bearingboys.co.uk/wordpress/2012/01/24/some-of-the-different-tools-used-in-industry/